Steps
1. Place the touchpad into its slot on the palm-rest assembly.
2. Align the screw holes on the touchpad to the screw holes on the palm-rest assembly.
3. Replace the five screws (M2x2.5) that secure the touchpad to the palm-rest assembly.
4. Lift up the flap below the touchpad cable and replace the screw (M2x2.5) that secures the touchpad to the palm-rest
assembly.
5. Connect the touchpad cable to the connector on the touchpad and close the latch to secure the cable.
6. Connect the keyboard-backlight cable to the connector on the touchpad and close the latch to secure the cable.
7. Connect the keyboard cable to the connector on the system board and close the latch to secure the cable.
8. Adhere the keyboard cable to the touchpad.
Next steps
1. Install the
assembly inner
2. Install the
WLAN
card.
3. Install the
4G WWAN card
4. Install the battery.
5. Install the
base
cover.
6. Install the
SIM
card.
7. Follow the procedure in
Speakers
Removing the speakers
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
SIM
card.
76
Removing and installing Field Replaceable Units (FRUs)
frame.
or
5G WWAN
card, as applicable.
After working inside your
Before working inside your
computer.
computer.