Table of Contents
Advertisement
Steps
1. Place the sensor board on its slot on the display back cover.
2. Route the sensor-board cable through the routing guides on the display back cover.
Next steps
1. Install the
display
panel.
2. Install the
display
bezel.
3. Install the
display
assembly.
4. Install the
WLAN
card.
5. Install the
4G WWAN card
6. Install the
base
cover.
7. Install the
SIM
card.
8. Follow the procedure in
Fingerprint Reader
Removing the fingerprint reader (Optional)
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
SIM
card.
3. Remove the
base
cover.
4. Remove the battery.
5. Remove the
assembly-inner
120
Removing and installing Field Replaceable Units (FRUs)
or
5G WWAN
card, as applicable.
After working inside your
Before working inside your
frame.
computer.
computer.
Advertisement
Table of Contents
