Table of Contents
Advertisement
About this task
The following images indicate the location of the smart card reader and provide a visual representation of the installation
procedure.
Steps
1. Align and place the smart-card reader on its slot on the palm-rest assembly.
2. Replace the two screws (M2x2) that adheres the smart-card reader to the palm-rest assembly.
3. Connect the smart-card cable to the connector on the USH board and close the latch.
Next steps
1. Install the
assembly inner
2. Install the battery.
3. Install the
base
cover.
4. Install the
SIM
card.
5. Follow the procedure in
Dummy SIM-card slot filler
Removing the dummy SIM-card slot filler
Prerequisites
1. Follow the procedure in
2. Remove the
SIM
card.
3. Remove the
base
cover.
4. Remove the
4G WWAN card
5. Remove the
WLAN
card.
6. Remove the
memory
modules.
7. Remove the
M.2 2230
8. Remove the
M.2 2230 solid-state drive from Slot
9. Remove the battery.
124
Removing and installing Field Replaceable Units (FRUs)
frame.
After working inside your
Before working inside your
or
5G WWAN
card, as applicable.
or
M.2 2280
solid-state drive from Slot 1, as applicable.
computer.
computer.
2, if applicable.
Advertisement
Table of Contents
