Kodak CHEVRON Service Manual page 9

28. Replace the roller bracket, fi 1m roller, and the lo-
cating pin.
29. Lubricate the pinion with No.
7101
grease, or equiva-
lent. Then replace the metering roller and pinion. Turn
the pinion counterclockwise to tighten it.
30. Lubricate the cI utch shaft
I ightly with No.
7101
grease,
or equivalent. Then replace the metering clutch assembly
and the clutch retainer ring (see Instruction No.
16).
SERVICE MANUAL NO. 5510-A
31.
Replace the back frame washers and the back frame;
then replace the back frame screws. The back frame should
be parallel with the front surface of the focus tube. Tol-
erance is
±
.001".
32. Check key assembly for clutch spring out of position
and worn teeth on ratchet. If necessary, replace with kit,
see Parts List No. 5510. Replace the key assembly and
key assembly screws.
33.
Replace the metering stud (arrow 1) and secure it
with a 3/1.6" hexagonal nut driver; then replace the metering
lever assembly and the assembly screw (arrow 2).
9