Advertisement
Troubleshooting
Problem
Possible causes
Bladder may be empty.
2-in-1 tank may not be
seated properly.
Pump may have lost
prime.
The pump belt may be
Reduced spray
broken.
OR
no spray
DirtLifter
The brush belt or pump
PowerBrush
belt is off or broken.
does not turn
ReadyTools dial may be
on the wrong setting.
Poor tool position.
(Hand held attachments
only).
Removable nozzle
may not be properly
attached.
Cleaner
not picking up
solution
2-in-1 tank lid is not
properly installed.
2-in-1 tank is not prop-
erly seated.
2-in-1 tank has picked up
maximum dirty water.
The lint screen may be
clogged.
Please do
not return
this product
to the store.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
WARNING
To reduce the risk of electric shock, push power pedal
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Push power pedal OFF; Refill bladder with clean hot
tap water and cleaning formula, refer to page 8.
Push power pedal OFF; remove tank and reseat
tanks.
Push power pedal OFF; after 1 minute turn ON and
press spray trigger.
Push power pedal OFF and unplug from the outlet.
To check if a pump belt has broken, you will need
a flat head screwdriver. A. Insert the blade end into
the slot of the belt access door to release. Examine
the belt for breakage. You should be able to see
the pump belt looped around the motor shaft. If it
is broken or missing, please refer to Replacement
Parts on page 14. A replacement belt may be
ordered by calling BISSELL Consumer Services.
Complete installation instructions will accompany the
replacement belt. B. When replacing belt access door
be sure to line up slots of belt access door with slots
in machine, slide door into place and snap shut.
Refer to remedy in "The pump belt may be broken"
above to check if brush belt or pump belt is broken.
Set ReadyTools dial to either FLOOR CLEANING or
TOOLS for the cleaning job.
Adjust angle; apply more downward pressure.
Make sure nozzle is on correctly by slightly raising
front of machine to line up slots on the base of the
machine with the hooks on nozzle. Attach at base
first and then click nozzle into place. Refer to image
5 on page 9.
Re-install lid; refer to the image on page 8.
2-in-1 tank must be firmly seated to function; remove
and reseat 2-in-1 tank.
Empty 2-in-1 tank, refer to page 9.
Clean out lint screen. Refer to page 9.
www.BISSELL.com
11
Advertisement
