Recording Management; Storage Device - HIKVISION DS-E00HGHI-B Series User Manual

Alarm Pop-up Window
The local monitor will pop up the alarming channel image when an alarm is triggered. It
requires to select the alarming channel(s) in Trigger Channel.
Buzzer Alarm
It will trigger a buzzer beep when an alarm is triggered.
Notify Surveillance Center
The device will send an exception or alarm signal to the remote client software when an
alarm is triggered.
Send Email
It will send an email with alarm information when an alarm is triggered.
PTZ Linkage
It will trigger PTZ actions (e.g., call preset/patrol/pattern) when smart events occur.
Audio and Light Alarm Linkage
For certain network cameras, you can set the alarm linkage action as audio alarm or light
alarm.
Note
Ensure your camera supports audio and light alarm linkage.
●
Ensure the audio output and volume are properly configured.
●
If you require to set audio and light parameters, please log into the network camera via
●
web browser to configure them.
3. Click Apply.

5.4 Recording Management

5.4.1 Storage Device

Initialize HDD
A newly installed hard disk drive (HDD) must be initialized before it can be used to save videos and
information.
Before You Start
Install at least an HDD to your video recorder. For detailed steps, refer to Quick Start Guide.
Steps
1. Go to Configuration → Record → Storage .
2. Select an HDD.
3. Click Init.
Digital Video Recorder User Manual
30