Table of Contents
Advertisement
Copyin^iburT^ge^Dubbiiig^
Connections you'll need to make.
• When connecting to a normal VCR, use the L Audio In jack for proper sound reproduction.
Playing (Source) VCR
Recording (Editing) VCR
TV for Monitoring
1
Insert a pre-recorded
tape into the Playing
(Source) VCR.
To Monitor Dubbing on Your TV
1
Turn your TV on and tune to the Recording
VCR channel (CH3 or CH4).
2
Insert a blank tape with
record tab Into the
Recording (Editing) VCR.
3
Select "LINE" Input mode on the
Recording (Editing) VCR. (See "Selecting
the Input Mode" at right.)
4
Press PLAY on the Playing VCR.
Press PAUSE at the desired starting point.
5
Press REC on the Recording VCR, and then
press PAUSE immediately thereafter.
6
Press PAUSE on both VCRs at the same
time, to begin copying.
To Edit Out Unwanted Parts
Press PAUSE on the recording VCR while copying is
in progress. Press PAUSE again to resume copying.
7
Press STOP on both VCRs to stop copying.
2
Set the VCR/TV Selector on the Recording
VCR to "VCR."
Selecting the Input Mode
Press INPUT.
The display will change in the order below.
C
Channel
Number
♦►LINE
or
Press CH A/T.
The display will change in the order below.
• When LINE is selected, "L" is displayed in the Multi
Function Display for about 4 seconds.
Caution:
Unauthorized exchanging and/or copying of copyrighted
recordings may be copyright infringement.
30
Advertisement
Table of Contents
