On-Screen Displays (Osd) (Function, Channel, Menu. Vcr Status & Clock, Warning) - Panasonic Omnivision PV-8450 Operating Instructions Manual

On^ScreenDisglaj^^OSD^
Function & Channel Display Warning and Instruction Displays
When a function button is
pressed, e.g. PLAY, or
you change channels,
a 4 second display
appears first in large
and then small characters.
(Some Station names may
also appear if Channel
Caption is set. See page 20.)
08
ABC
Menu Screen
1
Press ACTION to
display the menu.
2
Press
AT
and
^ to
make your selection.
• To get the most from each feature,
please read the Operating Manual
before attempting any operation.
- MENU —
SET UP VCR
SET UP FEATURE
[set CLOTkI
SET UP CHANNEL
IDIOMA/ LANQUE: ENGL ISH
SELECT:* ▼ KEY
SET :► KEY
END ;ACT ION KEY
VCR Status & Clock Display
Press DISPLAY to display or remove the
overlay shown below.
Function Channel Caption
Broadcast Audio
Being Received
(See page 26.)
• This display will
disappear in 5 seconds.
Tape Speed
(See page 5.)
Blank Tape/ No Video Signal Indication
These displays will alert you of a missed operation or
provide further instructions.
If no active channels are found
for CHANNEL MEMORY...
(See page 12.)
If you attempt to set or review
a Timer Recording and the
Clock is not set...
(See page 18.)
After a Timer Program has
been set...
(See page 18.)
If you press REC on the
remote control or VCR,
and a cassette is inserted
with no record tab...
(See page 17.)
If you press PLAY, FF, REW,
or REC on the remote
control or VCR without
a cassette inserted...
(See pages 16,17.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AOAIN
PLEASE SET CLOCK
BEFORE PROGRAMMING
TURN VCR OFF
FOR TIMER RECORDING
t-\
NO CASSETTE
PLEASE INSERT A CASSETTE
TO CANCa TIMER REC
PUSH POWER THEN STOP KEY
If you press POWER or STOP
during a Timer Recording...
(visible in VCR mode only)
(See page 19.)
If head cleaning becomes
necessary while playing
back a tape...
(See page 5.)
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
[ END:PLAY KEY
If you press a function button
other than STOP/EJECT or
POWER while the VCR is in
VCR Lock mode...
(See page 22.)
VCR LOCK ACTIVATED
Whenever a blank section of a tape comes up in
Play mode, or when the selected channel has no
broadcast signal with the Blue Back ON/OFF
Feature (page 21) set to ON, the TV screen will
turn solid blue.
If you press POWER. ACTION,
or PROG on the remote while
in TV or CABLE/DSS mode...
(See pages 28, 29.)
NOW TV/CABLE/DSS MODE
PLEASE PUSH VCR KEY
ON REMOTE
15