Table of Contents
Advertisement
Copying Your Tapes
(Dubbing)
Connection
VCR
Front of VCR
V1D£0IN2
L-AUDIO IN2-R
o
o o
(Video In Terminal on the
front of VCR is available)
Connect VIDEO OUT terminal on Playing VCR to VIDEO IN terminal on Recording VCR.
To monitor the dubbing, also connect a TV as shown.
Connect UL" and "R" AUDIO OUT terminals on Playing VCR to "L" and "R" AUDIO IN
terminals on Recording VCR (Rear).
In place of a Playing VCR, you can use other equipment, such as a Camcoder.
Simply connect the unit's Audio/Video outputs to the Recording VCR.
1
2
Playing (Source) VCR
Insert pre-recorded tape.
Recording (Editing) VCR
Insert blank tape with record tab.
Press INPUT to set VCR Input mode to LINE1 for
Video Input (Rear) or to LINE2 for Video Input
(Front). (See "Selecting the Input Mode" below.)
3
4
5
Press PLAY, then PAUSE/SLOW
Press REC, then PAUSE/SLOW
immediately to enter PLAY/PAUSE mode.
immediately to enter REC/PAUSE mode.
The operation of steps 4 and 5 must be done on both
playing and recording VCRs at the same time.
Press PLAY to start dubbing.
Press PAUSE/SLOW to start dubbing.
Playing VCR starts playback.
Recording VCR starts recording.
Press STOP to stop dubbing.
Press STOP to stop dubbing.
I To Monitor Dubbing on Your TV
1 Turn your TV on and tune to the Recording
VCR channel (CH3 or CH4).
2
Set the VCR/ TV Selector on the Recording
VCR to "VCR."
■ Selecting the Input Mode
Methodl:
Press INPUT repeatedly.
Channel Number <->LINE1 <->LINE2
Method2:
Press CH A/V. Display will change as below.
C
l
-v
(CABLE) (TV)
J
!-*—►LINEI •*—►125 or 69*-/
Dubbing tapes protected with Copy tSuard will
have poor quality results.
• "LI " or "L2" lights on Multi-Function Display
(about 4 sec.) when LINE1 or LINE2 is selected.
• LINE1: For rear audio/video connection.
LINE2: For front audio/video connection.
28
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Advertisement
Table of Contents
