Table of Contents
Advertisement
2. Operation
a. Writing onto the Cartridge
@ Push the Program Change Button @.
The indicator lights up.
@ Set each of the functions 1 to 8 (shown
on page 16) as you like.
@® Push the Patch Change Button @.
The indicator lights up.
@ Set the Protect Switch on the Memory
Cartridge to the OFF position.
® Push the Write Button @.
The indicator lights-up.
* ff you wish to leave the writing mode here, sim-
ply push the Write Button again, or return the
Protect Switch to the ON position.
© By using the Group Button @, the Bank
Button @ and the Number
Button @,
select the
patch
change
program
you
wish to write.
The Indicator of the Write Button goes out.
* Uniess the Nubmer Button is pushed, writing is
not done. That is, even if the Number
of the
patch change program you want is the same as
before, you cannot skip pressing the Number
Button. This, however, does not apply to the
Group or Bank Buttons.
@ Return the Protect Switch on the Memory
Cartridge to the ON position.
b. Selecting a Patch Change
@ Push the Patch Change Button ©.
The indicator lights up.
@ By using the Group Button @, the Bank
Button
@ and the Number Button @, call
the patch change program
you wish to
use.
* if the MKB-200 is switched on with the Car-
tridge connected, the patch change program of
Group
A,
Bank
1 and
Number
1 will
be
automatically called.
c. Edit
You can call any patch change program from the
Memory cartridge then change the setting of the
functions 1 to 8. When any alteration is made, the
Display shows a dot.
Bank
Number
oo
~
A dot lights up
* The editing operation does not automatically
rewrite the existing
patch change
program
unless
an
appropriate
writing
procedure
is
taken.
:
*To recail the original patch change program,
simply push the Patch Change Button @ then
the appropriate
Number
Button.
(When the
Patch Change Button has been already on, just
push the Number Button.)
7
Advertisement
Table of Contents
