Remote Control - Roland MKB-200 Owner's Manual

i. Remote Control
6
r
Damper Pedal DP-6
Pedal Switch DP-2
(Option)
1) Volume Jack (L) @
By connecting the Expression Pedal {EV-5) to
this jack, the Volume messages can be trans-
mitted on the channel assigned by the Lower
section.
2) Volume Jack (L + U) @
By connecting the Expression Pedal (EV-5) to
this jack, the Volume messages can be sent on
the both channels assinged by Lower and
Upper sections.
* These Volume Jacks can work at a time, the
pedal connected to the jack @ transmits the
Volume message to the Lower channel, the
pedal connected to the jack @ transmits to the
Upper channel separately.
wae
* When the Expression Pedal is connected to
the Volume Jack, the Volume Knob on the
MKB-200 does not work. That is, pedal oper-
ation has priority.
Expression Pedal
EV-5
(Option)
3) Modulation Jack ®
Connect a Pedal Switch to this jack, and Mod-
ulation message can be transmitted by pres-
sing the pedal, without using the Bender Lever.
4) Shift Jack @, ®
Connect the Pedal Switch DP-2 or DP-6 to the
Shift Jack UP, or to the DOWN, or connect two
Pedal Switches to the both jacks, and the
patch numbers 1 to 8 can be sequencially
called just by pressing the pedal(s). Pressing
the pedal will advance or back up one number.
5) Damper Pedal Jack (L) @
Connect a Pedal Switch to this jack, and
Damper Pedal message can be sent on the
channel assigned by the Lower section, by
pressing the pedal.
6) Damper Pedal Jack (L + U) @
Connect a Pedal Switch to this jack, and
Damper Pedal message can be sent on both
channels assigned by the Lower and Upper
sections, by pressing the pedal,
* These jacks @ and @ can work at the same
time, transmitting Damper Pedal message inde-
pendently on each channel.
15