High Pedal Disable Feature; Diagnostic Mode Feature; Starting And Stopping The Vehicle; Starting On A Hill - Ezgo LIBERTY Owner's Manual

Example: If all of the following events occur:
• the system senses that the accelerator pedal is pressed (power
applied to motor)
• the motor is stopped long enough that additional time can cause dam-
age to the motor
the Anti-Stall feature will interrupt power to the motor. To restore power to the
motor, cycle the key switch to the OFF position and then back to the ON posi-
tion.

High Pedal Disable Feature

High Pedal Disable prevents acceleration of the vehicle if the direction selec-
tor is changed or the key is turned on while the accelerator is pressed.

Diagnostic Mode Feature

With some electrical system failures, the Diagnostic Mode feature defaults to
a mode that allows the vehicle to operate at a decreased speed. If this feature
activates on your vehicle, contact your dealer.

STARTING AND STOPPING THE VEHICLE

All vehicles have an 'interlock system' that disables the controller and pre-
vents operation of the vehicle while the charger is connected. Remove the
charger plug from the receptacle and correctly store the cord before moving
the vehicle.
1. Sit in the driver's seat.
2. Press and hold the brake pedal.
3. Insert the key and turn to desired direction of travel.
NOTICE
4. Slowly press the accelerator pedal to start the motor.
5. When the accelerator pedal is released, the motor decreases the speed
of the vehicle. To stop the vehicle more quickly, press the brake pedal.
6. Remove the key from the switch before exiting the vehicle.

Starting on a Hill

The IntelliBrake™ (parking brake) will activate automatically when the vehicle
stops. To start the vehicle on a hill, press the accelerator pedal and the park-
ing break will release.
When in the R position, a warning alarm will activate to
indicate that the vehicle is ready to run in reverse.
OPERATION
35