Table of Contents
Advertisement
11.0 ZONE WALLPLATE OPERATION
1
Settings Button
Tap this to access zone wallplate settings ie: to adjust wall
plate colour theme and backlight settings.
2
Audio Source Input Selection Buttons
Choose between the audio sources connected to the system.
3
Volume Slider
Touch and slide the volume of a chosen audio source up and
down as desired.
4
Output Zone Name
The name of the output zone.
5
Volume +/- Buttons
Use these buttons to make fine adjustments to level control.
6
Mute On/Off Selector
Switches an muting or or off in the zone. Volume will
display at last used setting.
OPERATION
The zone wallplate or paging console connects to the controller via Cat5e UTP or similar cabling and can be located up to
200m away. Up to two plates (master or zone) can be connected on a single cable run, with a maximum of 8 wallplates
per system.
The zone wallplate allows for audio source selection and level control for the zone in which its located. This wallplate dis-
plays the status of the chosen audio source and the current audio volume level.
To make changes, simply tap the volume +/- buttons, use the volume slider or activate muting using the mute On/Off
selector.
To adjust the colour theme, tap the three lines icon on the top left of the screen. See section 13.0 for information on wall-
plate settings.
12.0 APP OPERATION
iOS/Android app under development. The app will connect to the local zone wallplate via Bluetooth and allow adjustments
of source and level control in that zone.
www.redbackaudio.com.au
Redback
A 4450 4 x 4 Audio Matrix/Switcher
®
(SELECTOR MODE)
1
FAMILY
Input Selection
DAB RADIO
DAB RADIO 2
2
FOXTEL
MP3 PLAYER
Volume Control
3
Vol
50%
Fig 6
Redback® Proudly Made In Australia
4
Vol+
5
Vol-
Mute
6
OFF
11
Advertisement
Table of Contents
