Brewing Coffee - Krups Simply Brew KM209D50 Manual

DESCRIPTION
A Lid
B Water tank
C Measuring spoon
D Permanent filter
E Funnel
F Funnel holder
G Base
H Thermal carafe lid
I Thermal carafe
Using the machine for the first time
„ Unbox the coffee machine and remove packaging and any other
items that are not part of the product (labels, ties, etc.). (Fig. 1)
„ Clean the coffee machine with a damp cloth or sponge. (Fig. 2)
Note: Before using your coffee maker for the first time, run a brew
cycle without coffee to rinse.

BREWING COFFEE

1. Place the machine on a solid, flat surface. Connect the appliance
to a 120 V~ electrical outlet. (Fig. 3)
2. Fill the water tank (B) with cold water to desired water level
(Max 60fl oz). (Fig. 4-6)
Note: Do not exceed the Max line (60fl oz) when brewing into
thermal carafe. Doing so could cause thermal carafe to overflow.
3. Place the thermal carafe (I) with its lid on the base (G) of the coffee
machine.
CAUTION: Make sure the thermal carafe is correctly placed on the
base before starting the brew cycle. If the carafe is not correctly
positioned on the base, hot water or coffee could overflow from
the appliance.
4. Place funnel (E) correctly in the coffee machine, then put permanent
filter (D) in the correct position. (Fig. 7-8)
20
J Blue indicator light – auto-on
function activated
K PROG (Timer programming)
L
HOUR
M MIN (Minute)
N STRENGTH (Coffee strength)
O START/PAUSE
P Red indicator light – brew
cycle started
5. Add the desired amount of ground coffee directly into the filter,
then close the top cover (A). The amount of coffee to use will vary
depending on the desired strength and taste. (Fig. 9)
6. Press the "START/PAUSE" button (O); the red LED light (P) will
come on and brewing will begin. (Fig. 10) During the brew cycle,
only the "START/PAUSE" button (O) will work.
Note: The cycle can be interrupted at any time by pressing the
"START/PAUSE" button (O); the red LED light will turn off.
7. When the brew cycle has finished, the unit will beep. Wait a few
minutes for the rest of the coffee to finish dripping into the thermal
carafe (I) before removing it by the handle. (Fig. 11)
Note: Wait a few minutes before making a second pot of coffee. Please
allow the brewing chamber to fully cool down and remember to empty
the used coffee grinds prior to making your next cup.
CAUTION: Be careful when opening the coffee maker lid after brewing
as this area will be hot and steam built up in the machine can cause
burns. Use the lift tab located on the front of the lid and be careful with
hands and face so it does not come in contact with any steam or hot
water.
USEFUL INFORMATION AND TIPS
The amount of coffee prepared will be less than the volume of water
you filled the tank with, as the ground coffee and filter partially
absorb it.
SETTING THE CLOCK
1. Press and hold the "HOUR" button (L) for three seconds. (Fig. 12)
The time on the LCD screen will flash. Use the "HOUR" (L) and
"MIN" (M) buttons to set the time. (Fig. 13 and 14)
2. After your selection, the time on the LCD screen will flash for five
seconds and the time is set.
USEFUL INFORMATION AND TIPS
Once the clock is set, it will continue to show the correct time. However,
the clock will be reset if the coffee machine is disconnected from the
EN
21