Table of Contents
Advertisement
Fault
Receiver cannot be
operated, switched on or off
USB device not recognised
Device automatically
switches off after a certain
time
Possible cause
Defective data stream -->
receiver blocked
USB device formatted for
wrong file system
Auto Standby function
enabled
35
Solution
Hold down the On/Stand-
by button on the receiver
or the remote control for
approx. 5 seconds
Disconnect mains plug for
approx. 5 seconds, then
reconnect receiver
Perform Flash-Reset:
Warning!
All personal settings will be
lost
> Remove mains adapter
from the receiver
> Press and hold
Standby and the up
arrow key at the
same time
> Reinsert the mains
adapter while Standby
and the up arrow key
are pressed down
> Keep both buttons
pressed down for
approx. 5 sec. then
release. "Factory
setting" appears in the
display
Format USB device in the
FAT32 file system
Check Auto Standby setting
and disable if necessary
Advertisement
Table of Contents
