For cable management, the rack rail kit might include one or both of the following options:
•
Rack rail hoop-and-loop strap
•
Cable management arm
Rack mounting interfaces
The server rails can be installed in a rack that has the following mounting interfaces:
Round-hole
The illustrations used in this procedure show an icon on the upper right corner of the image. This icon
indicates the type of mounting interface for which the action illustrated in the image is valid.
Rail identification markers
The rack rail option support is dependent on these two factors:
•
The height and weight of the chassis as determined by the front- and rear-end server configurations.
•
The depth of the chassis as measured from the edge of the front panel (without the front bezel) to the
edge of the rear panel.
To ensure compatibility between the rack rails and the server, verify that the rail number labels on the chassis
match the ones stamped on the rails.
•
Rail number labels on the chassis
Rail #3 and #5
•
Rail identifier stamps on the inner rail of the friction rack rail
Square-hole
Threaded round-hole
Hardware options installation
84