Table of Contents
Advertisement
Remote Programming
Your system comes with the remote controls already programmed, how-
ever if you are replacing or adding additional remote controls, they
must be programmed to the system prior to operating the system. To
program the remote, you need to know where the valet button is lo-
cated. If the horn honk is not connected, the main unit LED needs to be
visible for visual confirmation. If you cannot locate or access the main
unit, it is recommended that you visit your authorized dealer for remote
programming. The system is capable of accepting up to four remote
controls.
1.
Turn key to the ON position
2.
Within 10 seconds, press and release the valet button one time.
3.
Within 10 seconds, press and hold the valet button. The LED on
the module flashes one time and the horn (if connected) honks to
confirm entry into remote programming. Do not release the valet
button.
4.
Press the
firm the remote has been programmed.
5.
Release the valet button.
6.
Turn the key to OFF position. The horn sounds one long honk to
confirm that remote programming has been excited.
The programming routine exits if any of the following occurs:
•
The ignition is turned off
•
There is no activity for 30 seconds
•
The Valet button is pressed too many times
10
button on the remote control. The horn honks to con-
AUX
AUX
AUX
Your 1-way remote coin cell battery can be changed by using a small at blade screwdriver to pry case apart. Replace battery and then snap case together.
© 2015 Directed. All rights reserved.
Advertisement
Table of Contents
