Key Takeover - Directed 4105A Owner's Manual

parking lights flash, in diesel vehicles the engine starts after the
WAIT-TO-START timer has expired.
3. Once the vehicle has started, it will run for the pre- pro gram med
period of time (12, 24, or 60 minutes) or until a shutdown input
is trig gered.
* The factory setting is one press but this can also be programmed for
two or three presses maximum (See your authorized Directed installer
for the amount of presses programmed).
Record the number of presses to activate remote start here:____

Key Takeover

When you are ready to drive the vehicle:
1. Unlock the doors.
2. Enter the vehicle. Do not step on the foot brake.
3. Insert the key, turn it to the run (not start) position. Step on the foot
brake. The remote start is disabled and the parking lights turn off.
4. Disengage the parking brake and begin driving.
Note If your vehicle uses a Smart Key or PTS (Push-To-Start) system,
please refer to the vehicle specific instructions included with
the owner's guide of the interface module or consult your
authorized dealer.
Category
Control
© 2015 Directed. All rights reserved.
Toggles
Warning! It is unsafe to operate a vehicle's motor in a
garage or other closed off area. Breathing the ex haust
from the vehicle is hazardous to your health. Never
activate the remote start in an enclosed space.
Bank and
present
indicator
REW
1
Tune mode
indicator
11:53
CATEGORY CH
XM1-1 CH-001
FF PLAY/PROG
2 3
Channel
and text
indicator
NR DISC- DISC+
4 5 6
7