Technical Data; Assembly Instructions; Inserting/Replacing The Brush; Mounting The Guiding Roller - Grizzly ERB 550-1MS Translation Of The Original Instructions For Use

Technical data

Electric universal cleaning brush .............
ERB 550-3U, ERB 550-2S, ERB 550-1H,
ERB 550-1MS, ERB 550-4U
Motor voltage .............. 230-240 V~, 50 Hz
Power P .......................................... 550 W
Protection class ...................................
Protection category............................IPX0
Idling speed n ................600-1200 min
max
Sound pressure level
(L ) .....................81.5dB(A); K
pA
Sound power level (L
measured ...... 93.9 dB(A); K
guaranteed .............................. 96 dB(A)
Vibration (a )
h
additional
handle .............. 3,542 m/s
handle .............. 2,421 m/s
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration
of conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another. The stated
vibration emission value may also be used
for a preliminary exposure assessment.
Warning: The vibration emission
value may differ during actual use of
the power tool from the stated value
depending on the manner in which
the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours.
= 3 dB
pA
)
WA
= 2.04 dB
WA
; K= 1,5 m/s
2
; K= 1,5 m/s
2
For this purpose all parts of the op-
erating cycle have to be considered
(for example, times when the elec-
tric tool is switched off and times
when it is switched on but running
without any load).
Assembly
II
instructions
-1
The brush support (15), the hexa-
gon socket wrench (16) and the
metal brush (17) are situated in the
two compartments in the additional
handle (13).

Inserting/replacing the brush

2
1
Nylon brush (10/18):
2
Release/fasten the fixing screw on the
inside of the nylon brush (10/18) on the
motor head (12) using the hexagon socket
wrench (16).
2
Metal brush (17a):
1. Push open the brush support (15)
and attach it as it is to the motor head
(12) (see A ). Release the brush sup-
port (15) and it will spring back into its
initial position.
2. Insert the desired brush.
3. To remove the brush, push the brush
support (15) open and remove the
brush (see B ).

Mounting the guiding roller

1. Insert the guiding roller (11) on to
3
the motor head (12). It locks into
place audibly.
GB
23