Equipment Response Time; Table 6. Recommended Separation Distances - Nonin 9843 Operator's Manual

This table details the recommended separation distances between portable and mobile RF
communications equipment and this device.
This device is intended for use in an electromagnetic environment in which radiated RF disturbances are
controlled. Users of this device can help prevent electromagnetic interference by maintaining a minimum
distance between portable and mobile RF communication equipment (transmitters) and the device as
recommended below, according to maximum output power of the communications equipment.
Rated Maximum Output
Power of Transmitter W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation
distance d in meters (m) can be estimated using the equation applicable to the frequency of the
transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to the
transmitter manufacturer.
NOTES:
• At 80 MHz and 800MHz, the separation distance for the higher frequency range applies.
• These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption
and reflection from structures, objects, and people.

Equipment Response Time

If the signal from the sensor is inadequate, the last measured SpO
seconds and are then replaced with dashes.
SpO
Standard/Fast Averaged SpO
Pulse Rate Values
Standard/Fast Averaged Pulse Rate
Equipment Delays
Display Update Delay
36
Table 6 : Recommended Separation Distances
Separation Distance According to Frequency of Transmitter
150 kHz to 80 MHz
d = 1.17 P
0.12
0.37
1.2
3.7
12
Values
2
2
1.5 seconds
80 MHz to 800 MHz
d = 1.17 P
0.12
0.37
1.2
3.7
12
2
Average
4 beat exponential
Response
4 beat exponential
Delay
Technical Information
800 MHz to 2.5 GHz
d = 2.33 P
0.23
0.74
2.3
7.4
23
and pulse rate values freeze for 10
Latency
2 beats
Latency
2 beats