Federal Signal Corporation DFC-WC-DUR21 Manual page 3

Installing the DFC-WC-DUR21 Push Bumper Wire Cover on the 2021+ Dodge
To install the DFC-WC-DUR21 Push Bumper Wire Cover:
1. Place the wire covers (Items 1 and 2) as shown in Figure 2. Note that the figure is of the driver-side wire
cover (Item 1).
2. Install the supplied hardware as shown in Figure 3.
3. Tighten all hardware to 8 ft-lb.
Care Instructions
Regularly clean the textured powder coat finishes with either a soft cloth or a brush with mild soap and warm
water. Avoid using any harsh chemicals, as this will damage the product's finish. Pressure washing this product
is the most efficient way to remove heavy dirt and grime. The pressure washer should be used on a low-
pressure setting with filtered water for best results. Using high pressure can damage the product's finish.
DFC-WC-DUR21 Push Bumper Wire Cover
Federal Signal www.fedsig.com
Figure 2 Wire cover placement (Driver side shown)
1
Figure 3 Install hardware
6
4
1
5
3
Durango
® ®
3