Advertisement
Installing the DFC-WC-DUR21 Push Bumper Wire Cover on the 2021+ Dodge
Introduction
This document contains instructions for installing the DFC-WC-DUR21 Push Bumper Wire Cover in a 2021+
Dodge Durango. This product is to be installed only on the DFC-PB-DUR21 Push Bumper.
Unpacking the Product
After unpacking the product, inspect it for damage that may have occurred in transit. If it has been damaged,
do not attempt to install or operate it. File a claim immediately with the carrier, stating the extent of the
damage. Failure to identify damage before installation could lead to the rejection of any claim. Carefully check
all envelopes, shipping labels, and tags before removing or destroying them. Ensure that the parts listed in
Table 1 are included in the package. If you are missing any parts, contact Federal Signal Customer Support at
1-800-264-3578, 7 a.m. to 5 p.m., Monday through Friday (CT).
THREAD DAMAGE AND GALLING: To prevent thread damage and galling, anti-seize lubricant must
be used on all stainless steel fasteners.
Installing the DFC-WC-DUR21 Push Bumper Wire Cover
FASTENERS PRECAUTION: Double-check all fasteners before initial use and periodically in the
future to ensure proper function and safety.
FOR CALIFORNIA RESIDENTS ONLY; PROPOSITION 65 WARNING: Some products may contain
chemicals such as DEHP, which can cause cancer, birth defects, or other reproductive harm. For
more information, go to www.p65warnings.ca.gov.
2
Table 1 Kit contents
Item Description
1
Driver Side Wire Cover
2
Passenger Side Wire Cover
3
No. 6-32 x 2-inch Button Head Bolt
4
No. 6 Lock Washer
5
No. 6 Flat Washer
6
No. 6-32 Hex Nut
Figure 1 Kit items
Item 1
Durango
®
Qty.
1
1
4
4
4
4
Item 2
DFC-WC-DUR21 Push Bumper Wire Cover
Federal Signal www.fedsig.com
®
Advertisement
