Table of Contents
Advertisement
Disassembly
Removing the System Memory (RAM)
Figure 6
RAM Module
The computer has two memory sockets for 200 pin Small Outline Dual In-lin e Memory Modules (SO-DIMM) supporting
Removal
DDR3 1066/1333MHz. The main memory can be expanded up to 8GB. The SO -DIMM modules supported are 1GB,
2GB and 4GB and DDRIII Modules. The total memory size is automatica l ly detected by the POST routine once you turn
a. Locate the memory
on your computer.
socket.
b. Pull
the
release
latches.
Memory Upgrade Process
c. Remove the mod-
ule.
1. Turn off the computer, remove the battery
2. The RAM modules will be visible at point
3. Gently pull the two release latches (
arrows
a.
Contact Warning
Be careful not to touch
the metal pins on the
module's
connecting
edge. Even the clean-
est hands have oils
which can attract parti-
cles, and degrade the
module's
perfor-
mance.
4. The RAM module
5. Pull the latches to release the second module if necessary.
4. RAM Module
6. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
7. The module's pin alignment will allow it to only fit one way. Make sure the module is seated as far into the slot as it
will go. DO NOT FORCE the module; it should fit without much pressure.
8. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
2 - 10 Removing the System Memory (RAM)
&
2
(Figure
6b).
1
will pop-up
(Figure
4
(page 2 -
5) and the component bay cover
on the main board
(Figure
6a)
1
)
on the sides of the memory socket in the direction indicated by the
3
b.
2
3
6c), and you can then remove it.
(page 2 -
8).
.
c.
4
Advertisement
Table of Contents
