Table of Contents
Advertisement
How to Use the Remote Commander
(RM-VP1)
Use the remote commander to turn on the STR-G1ES and to
control the pointer on the TV screen.
¢ When using the remote commander, keep the button
paraltel to the floor.
¢ Press the button on the remote commander to turn on the
unit.
* A slight move of the wrist is all you need to direct the
pointer.
* By moving the remote commander, you can position the
pointer onto a menu or control button on the TV screen.
* Activate control buttons selected by the pointer by pressing
the button on the remote commander.
« If you place the commander on a flat surface, the on-screen
display will disappear after a few seconds.
¢ The on-screen display will appear each time you touch or
press the button on the remote commander.
¢ The pointer position freezes when you hold down the
button.
Notes
« If the pointer begins drifting on the screen even when the
remote commander is stationary, place the remote
commander on a flat surface until the on-screen display
disappears. The pointer should behave normally when
you use the remote commander again.
* The on-screen display may not appear when you touch
the remote commander button if your hand is too dry.
Since the remote commander is comprised of
delicate circuitry and parts, do not subject it to
sudden changes in temperatures or shocks.
FUNCTION: Selects the program source, selects the SET
UP menu, and turns off power to the unit and
other electrical equipment.
VOLUME: Controls the volume of the program source
Control panel: Activates the respective program source
SOUND: Selects the sound fieid
[i) Click button
Press this button to activate a button or select a menu
item on the screen.
[2] Battery compartment
insert batteries here (see page 6).
Note
If the on-screen display does not appear even when
batteries are inserted into the remote commander,
reinsert the batteries and place the remote commander
on a flat surtace for about 10 seconds.
Advertisement
Table of Contents
