Troubleshooting - cecotec Conga Flash Connected Titanium Instruction Manual

ENGLISH
- Remove the battery and store it in a safe, dry place if the device will not be used for a long
period of time.
- To replace the battery, follow the instructions below:
1. Unscrew the 2 screws on the battery slot, remove the battery cover and the battery. Fig. 27
2. Insert the new battery with the battery label facing up. Fig. 28
3. Place the battery and the battery cover in its place and fix properly the screws back
again.

6. TROUBLESHOOTING

Robot signal
1 beep
2 beeps
Steady
red light
3 beeps
4 beeps
46
Cause
Omnidirectional wheel
error.
Side brushes error
Suction motor error
Main brush error
Solution
Clean the omnidirectional wheel and
press the Start/Pause button to restart
the robot vacuum cleaner.
Clean the side brushes and press the
Start/Pause button to restart the robot
vacuum cleaner.
Remove the tank and empty it.
Remove the robot filter and shake off
the dirt.
Remote and clean the main brush and
press the Start/Pause button to restart
the robot vacuum cleaner.