Operation - cecotec Conga Flash Connected Titanium Instruction Manual

ENGLISH
5. Place the robot on the charging base and make sure the charging terminals on the robot
match those of the charging base. Once the robot is properly placed, it will beep once
and the power button will light up. If the light is oscillating orange, it means the battery
is not completely charged. To ensure the maximum cleaning time, wait until the light
turns into steady blue, as this will indicate the battery is fully charged and the robot is
ready to clean. Fig. 18

4. OPERATION

Starting the cleaning. Fig. 19
1. Hold down the Start/Pause button on the robot to turn it on.
2. Press the Start/Pause button on the robot vacuum cleaner or on the app to start
cleaning.
Note:
- If the robot runs out of battery while cleaning, it will automatically return to the charging
base. Once the battery is fully charged, the robot can start a new cleaning cycle.
- If there is no good access to the charging base, the robot will not be able to return to it. If
this happens, place it manually on the charging base.
Pausing the cleaning.
1. Press the Start/Pause button on the robot vacuum cleaner or on the app to pause the
cleaning process.
2. Press the Start/Pause button on the robot vacuum cleaner or on the app to resume the
cleaning process.
Off. Fig. 19
Hold down the Start/Pause button on the robot to turn it off.
Warning
The robot vacuum cleaner has a power switch (with positions I and 0) located on the lower
part of the main body. If the robot will not be used for long periods of time, it is recommended
to turn it off using this switch. As a safety measure, if the robot is switched off (0 position),
it will restore the factory default settings. To operate the robot, the switch must be in the on
position (I)
Cleaning modes
This robot includes different modes and functions that can be activated via the app.
42
Fig. 19