Creda Double Oven Instruction & Installation Manual page 30

CARE AND CLEANING
3. OVEN DOORS
CONTROL PANEL
TRIMS
4. REPLACEMENT OF THE OVEN LAMP
TOP OVEN LAMP (NOT ALL MODELS)
MAIN OVEN LAMP
5. HOW TO CLEAN THE LAMP LENS
TOP OVEN LAMP (NOT ALL MODELS)
MAIN OVEN LAMP
30
(a) Control Panel
Regularly wipe with a clean, damp cloth and polish with
a clean, dry cloth.
(b) Trims
It is advisable to clean the trims regularly to prevent any
build up of soiling which may detract from the appearance
of the cooker. The recommended method of cleaning is
to wipe over the trims with a clean, soft cloth wrung out
in hot water, or mild non abrasive cleaner.
OVEN
(If in doubt try the cleaner on a small area of trim which is not
DOORS
noticeable in normal use), then after wiping with a cloth wrung
out in clear water, dry with a clean, soft cloth.
(c) Inner Door Panels & Glass
Open the door fully. The glass panel may now be washed.
Stubborn stains can be removed by using a well soaped,
fine steel wool soap pad.
DO NOT use scouring pads, or abrasive powder, which will
scratch the glass.
Warning: Before removing lamp lens, please ensure that the
electricity supply to the appliance is switched off and the appli-
ance is fully cold.
Open the oven door and remove the oven shelves. Using
a thick cloth, grip the lamp lens, unscrew anti-clockwise
and remove the lens.
Carefully unscrew the bulb anti-clockwise. Fit replacement bulb
(15W 300°C SES). Fit replacement bulb and refit lens.
Warning: Before cleaning lamp lens, please ensure that the elec-
tricity supply to the appliance is switched off and the appliance
is fully cold.
Open the oven door and remove the oven shelves. Using
a thick cloth, grip the lamp lens, unscrew anti-clockwise
and remove.
Clean with a non-abrasive cleansing cream and refit
lamp lens.
DO NOT use scouring pads, or abrasive powder, which will
scratch the glass lens