Smo 20 - At Your Service; Set The Indoor Climate - Nibe SMO 20 User Manual

SMO 20 – at your service

Set the indoor climate

OVERVIEW
Sub-menus
INDOOR CLIMATE 1
temperature
scheduling
advanced
For the menu INDOOR CLIMATE
menus. Status information for the relevant menu can be
found on the display to the right of the menus.
temperature Setting the temperature for the climate sys-
tem. The status information shows the set values for the
climate system.
scheduling Scheduling heating and cooling. Status inform-
ation "set" is displayed if you set a schedule but it is not
active now, "holiday setting" is displayed if the vacation
schedule is active at the same time as the schedule (the
vacation function is prioritised), "active" displays if any part
of the schedule is active, otherwise it displays " off".
advanced Setting of heat curve, adjusting with external
contact, minimum value for supply temperature, room sensor
and cooling function.
MENU 1.1 - TEMPERATURE
NIBE SMO 20
off
there are several sub-
temperature 1.1.1
temperature cooling 1.1.2
Accessories are required to control the climate system using
room sensors. If you choose Menu 1.1 and do not have the
cooling accessory, you come directly to Menu 1.1.1.
Choose between heating or cooling and then set the desired
temperature in the next menu "temperature heating/cooling"
in menu 1.1.
Set the temperature (with room sensor
installed and activated):
heating
Setting range: 5 – 30 °C
Default value: 20
cooling (accessory required)
Setting range: 5 – 30 °C
Default value: 25
The value in the display appears as a temperature in °C if
the climate system is controlled by a room sensor.
Caution
A slow heating system such as underfloor heating
may not be suitable for control using the control
module's room sensors.
To change the room temperature, use the control knob to
set the desired temperature in the display. Confirm the new
setting by pressing the OK button. The new temperature is
shown on the right-hand side of the symbol in the display.
Setting the temperature (without room
sensors activated):
Setting range: -10 to +10
Default value: 0
The display shows the set values for heating (curve offset).
To raise or lower the indoor temperature, increase or reduce
the value on the display.
Chapter 4 | SMO 20 – at your service 13