Assembly - Husqvarna DS150 Operator's Manual

protective equipment does not erase the risk of
injury. The personal protective equipment decreases
the grade of injury if an accident occurs. Let your
dealer help you select the right equipment.
• Use approved eye protection while you operate the
product.
• Do not use loose, heavy and not applicable clothing.
Use clothes that let you move freely.
• Use approved protective gloves that enables a solid
hold.
• Use rubber protective gloves that prevents skin
irritation from wet concrete.
• Use an approved protective helmet.
• Always use approved hearing protection while you
operate the product. Noise for a long period can
cause noise-induced hearing loss.
• The product makes dust and fumes that contain
dangerous chemicals. Use an approved breathing
protection.
• Use boots with steel toe-caps and non-slip soles.
• Make sure that you have a first aid kit near.
• Sparks can occur when you operate the product.
Make sure that you have a fire extinguisher near.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with safety devices that are
damaged or do not operate correctly.
• Do a check of the safety devices regularly. If the
safety devices are damaged or do not operate
correctly, speak to your Husqvarna service agent.
• Do not make modifications to safety devices.
Introduction
WARNING:
safety chapter before you assemble the
product.
To install the wheel kit
The wheel kit is not supplied for all models.
1341 - 005 - 28.09.2023
Read the warning

Assembly

Read and understand the
To do a check of the carriage lock
1. Turn the knob to lock the drill motor carriage.
2. Feel by hand that the drill motor carriage is locked to
the drill column.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product. Save all warnings and instructions
for future operations.
• Stop the drill motor, disconnect the power supply
and remove the drill motor before maintenance of
the product.
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved servicing dealer.
• Do the maintenance to make sure that the product
operates correctly. Refer to
page 12 .
• Attach the wheel kit to the bracket at the rear end of
the bottom plate and tighten the screws.
Read the warning
Daily maintenance on
5