Assembly; Fit The Wheel Kit; Secure The Stand - Husqvarna DS150 Operator's Manual

Fit the wheel kit

• Fit the wheel set to the carriage column.
• Fit the wheel set to the bracket on the rear of the
baseplate and tighten the screws.

Secure the stand

There are three methods for fixing the stand.
• Securing with vacuum plate
• Fixing with expander or anchor
• Fixing with threaded rod, washer and lock nut
Securing with vacuum plate
WARNING! The vacuum plate must never
!
be used for ceiling or wall drilling.
Careless or incorrect use can result in
serious, even fatal injury.
If the vacuum plate is used, make sure
the support surface is not porous and
can loosen. Make sure that the vacuum
pump has sufficient power to secure the
vacuum plate.
• Fit the vacuum gasket to the baseplate.
• Connect the vacuum pump to the quick coupling for
vacuum pressure on the baseplate.
• Place the bottom plate in the desired position.
• Switch on the vacuum pump. A minimum pressure of
635 mm Hg (25 inch Hg) must be reached for the
baseplate to seal tightly against a surface.

ASSEMBLY

Fixing with expander or anchor
!
DS150
• Drill a hole for the expander/anchor at a distance of
293 mm (11.5") from the center of the hole.
293 mm
(11,5")
• Screw the baseplate tight. Check carefully that the
expander is secured correctly.
• The bottom plate can be adjusted to the surface by
using the leveling adjustment screws. Use the feed
handle.
IMPORTANT! When drilling ceilings, only
expander or anchor suitable for surfaces
exposed to tensile forces should be
used.
Use only expander or anchor which is
approved for current application.
–
English 11