Assembly - Husqvarna DS900 Operator's Manual

To do a check of the end stop of the drill column
1. Make sure that the end stop is installed correctly at
the top of the drill column.
2. Make sure that the drill motor carriage stops when it
touches the stop plate.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you use the product. Save
all warnings and instructions for future
operations.
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To install the wheel kit (accessory)
1. Put the bracket (A) in the holes in the bottom plate.
6
A
B
• Stop the drill motor, disconnect the power supply
and remove the drill motor before maintenance of
the product.
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved servicing dealer.
• Do the maintenance to make sure that the product
operates correctly. Refer to
page 10 .

Assembly

2. Attach the wheel kit with the clips (B).
To attach the drill motor
WARNING: Disconnect the drill motor from
the power supply.
1. Remove the drill bit from the drill motor.
2. Lock the carriage lock.
3. Attach the drill motor in the lock clamp on the drill
motor carriage.
4. Push the drill motor fully down to the bottom of the
lock clamp (A).
Daily maintenance on
1324 - 001 - 11.10.2019