Programmed Recording - Panasonic Palmcorder PalmSight PV-L50 Operating Instructions Manual

Programmed Recording
Set a recording start and stop time. Or, set
a 5 or 10 second interval recording to be
done each minute.
Os
op
DISPLAY MENU
10MIN. — 2GMIN. — 30MIN.— TO TAPE END
INTERVAL *2 INTERVAL * 1
10 SEC/MIN. ^" 5 SEC/MIN.
*1 Interval 5 SEC/MIN:
Record 5 seconds each minute.
*2 Interval 10 SEC/MIN:
Record 10 seconds each minute.
Note:
* Start time may not be set over 24 hours
from current time.
* Camcorder shuts off at tape end, or 12
hours after Interval Recording starts.
* To cancel, set POWER to OFF.
_ Camera Recording
"E S d - CITAR S
Before you begin...
* Connect Camcorder to power source.
Use AC Adaptor for longer recordings.
* Insert cassette with record tab (page 15).
* Set POWER to CAMERA.
1 Press MENU for MENU mode.
Press UP A or DOWN ¥ to select
PROGRAMMED
--- MENU --- PAGE 1/2
PROGRAMMED REC
TITLE H
TALLY LAMP ; ON
AND-BY RELEASE : OFF
CLOCK SET
SELECT: PUSH V/A KEY
2 Press DISPLAY. (Current time is
displayed.)
Each additional press of DISPLAY
increases start
SELECT: PUSH 'Y/A KEY
SET :
Press DOWN ¥ to select
ua. Press DISPLAY repeatedly to
select one of the options shown at
the left.
START ; 10:20PM
` 10MIN.
SELECT: PUSH /À KEY
SET : PUSH DISPLAY KEY
: RECORO KEY
To cancel the setup, press MENU
twice.
Press RECORD/PAUSE to place
Camcorder in stand-by mode.
STAND-BY
START ; 10:20PM
REC TIME ; 10MIN.
10:20:00PM
AN 12000
Recording will be done as scheduled.
27