Battery Refresh - Panasonic Palmcorder PalmSight PV-L50 Operating Instructions Manual

Sa labo Power
A fully OS Battery provides a maximum of about 1 hour 10 minutes of continuous
use (LCD monitor off) or about 55 minutes (LCD monitor on). Actual time may vary due to
operating conditions. Using the Built-in Light decreases operating time.
1 Attach Battery
(O) Align Battery with top of mounting
surface.
BATTERY @ Press and snap into place.
PACK 2
Remove Battery
While sliding BATTERY RELEASE,
remove Battery.
Battery Refresh
This feature completely discharges Battery before recharging begins.
Use after about every 5 charges for optimum Battery performance.
1 Plug in AC Adaptor.
* POWER Lamp stays on as long as
Adaptor is plugged in.
CHARGE Lamp
2 Place Battery into Adaptor.
3 Press BATTERY REFRESH.
The CHARGE Lamp flashes during
discharge then stays lit until charging
is complete.
If BATTERY REFRESH is pressed
^ by mistake, remove Battery from
3 BATTERY 2 4 Adaptor and reinsert it for normal
REFRESH
,
charging.
4 Remove Battery.
* Charging takes about 5 hours when
Battery Refresh is used.
* Battery will not operate in extremely high
temperatures.
For assistance, please cail : 1-800-211-PANA(7262)
1 2 or send e-mail to : consumerproducts € panasonic.com