Language; Date And Time (Set Date And Time); Unit Configuration (Units); Buttons On Product (Enable/Disable Settings) - Grundfos CRE Series Installation And Operating Instructions Manual

Example: 192.168.1.1
9.34.6.6 Primary DNS
Use this function to manually set the primary DNS
address.
Example of primary DNS address format: 8.8.8.8
9.34.6.7 Secondary DNS
Use this function to manually set the secondary DNS
address.
Example of secondary DNS address format: 4.4.4.4

9.35 Language

The function is only available in the HMI 300 and 301
operating panels.
Use this function to select the desired language from
the list.

9.36 Date and time (Set date and time)

The function is only available in the HMI 300 and 301
operating panels.
Use this function to set the date and time as well as
how you want them to be viewed in the display.
• Select date format
- YYYY-MM-DD
- DD-MM-YYYY
- MM-DD-YYYY
• Select time format
- HH:MM 24-hour clock
- HH:MM am/pm 12-hour clock
• Set date
• Set time.

9.37 Unit configuration (Units)

The function is only available in the HMI 300 and 301
operating panels.
Use this function to select SI or US units. You can
make the setting for all parameters or customize for
each individual parameter.
9.38 Buttons on product (Enable/disable
settings)
Use this function to disable the option to make
settings for protective reasons.
• If you use Grundfos GO and set the buttons to
Not active, the buttons on the HMI 200 or 201
operating panel are disabled, except the Radio
communication button.
• If you disable the buttons on pumps fitted with the
HMI 300 or 301 operating panel via Enable/
disable settings, you can still use the buttons to
navigate through the menus but you cannot make
changes directly on these operating panels. A lock
symbol appears in the display. However, you can
74
unlock the motor temporarily and allow settings by
pressing the Up and Down buttons
simultaneously for at least 5 seconds.

9.39 Delete history

The function is only available in the HMI 300 and 301
operating panels.
Use this function to delete the following historical
data:
• Delete operating log
• Delete energy consumption.

9.40 Define Home display

The function is only available in the HMI 300 and 301
operating panels.
Set the Home display to show up to four user-defined
parameters.

9.41 Display settings

The function is only available in the HMI 300 or 301
operating panels.
Use this function to adjust the display brightness. You
can also set whether or not the display is to switch off
if no buttons have been activated for a period of time.

9.42 Store settings (Store actual settings)

Use this function to store the current settings to
enable the user to go back to a previous set of
settings.

9.43 Recall settings (Recall stored settings)

Grundfos GO
In this menu, you can recall stored settings from a
number of previously stored settings that the pump
then uses.
Advanced operating panel
In this menu, you can recall the last stored settings
that the pump will then use.
9.44 Undo
The function is only available in Grundfos GO.
Use this function to undo all settings made with
Grundfos GO in the current communication session.
Once you have recalled settings, you cannot undo.
9.45 Pump name
The function is only available in Grundfos GO.
Use this function to give the motor a name. The
selected name then appears in Grundfos GO.