Advertisement
SAFETY NOTICE:
Please read this entire manual before you install and use your new room heater. Failure
to follow instructions may result in property damage, bodily injury, or even death.
Contact local building orfire officials about restrictions and installation inspection
requirements in your area.
Planning The Installation
We suggest that you have an authorized Travis Industries dealer install your stove. If you install the
stove yourself, your authorized dealer should review your installation plans.
Check with local building officials for any permits required for installation of this stove and notify your
insurance company before proceeding with installation.
Preparation for Installation
•
Check for damage to the exterior of the stove (dents should be reported, scratches can be fixed by
applying touch up paint).
•
Check the interior of the firebox (replace cracked firebrick and make sure baffle is in place).
IOI
The stove can be lightened by removing the firebricks and baffle (pg 27) - replace before operation.
Stove Leg Installation
Raise the stove 8" (use lumber) and attach the included legs following the directions in Figure 2 .
Attach each leg to the stove by
inserting a bolt and washer through the
hole or slot in the leg and into the
threaded hole on the stove.
.
.
.
't
1·
These rubber-tipped bolts are for leveling the stove.
/.......,, - - - - - -
Make sure they contact the floor. Do not adjust
~
with weight on the legs, the rubber tips may tear.
Pipe Heat Shield Installation
Install the pipe heat shield following the
directions in Figure
3.
©Travis Industries
93508039
9116"
Socket Wrench
shipped inside the
stove. Install
it by
sliding this joggle over
the back heat shield.
Figure 2
Figure 3
4040820
Advertisement
