Stanley SG 4200B Original Instructions Manual page 9

Rated voltage Urated:
Rated current:9,6 A (230V~) /5,8A(400V~)/ 8,3 A (12V d.c.)
Frequency Frated:
Drive engine design:
Single-cylinder forced air-cooled 4-stroke OHV
Displacement:
Fuel type:
Tank capacity:
Engine oil: Appox.1.1 l (15W40/<0
Net Weight:
Guaranteed sound power level L
Power factor cos φ:
Power class:
Max. temperature:
Max. altitude (above mean sea level):
Spark plug:
Operating mode S1 (continuous operation)The
machine can be continuously operated with the
quoted power output.
Operating mode S2 (temporary operation)The
machine may be temporarily operated with the
quoted power output. Afterwards the machine must be
stopped for a while to prevent it from overheating
5. Layout
1 Tank indicator
2 Fuel cap
3 230 V~ socket-outlets
4 400 V~ socket outlet
5 1x 12V DC connector
6 Earth connection
7a Overload cut-out for 230V
7b Overload cut-out for 400V~
7c Overload cut-out for 12V
8 Voltmeter
9 Oil drain plug
10 Oil filler plug
11 Oil shortage cut-out
12 Electro starter key
13 Choke lever
14 Pull cord
2 X 230 V~
1 X 400V 3~
1 X 12V
50 Hz
3
389 cm
Normal unleaded petrol
25 l
o
C: 5W30)
78 kg
: 97 dB(A)
WA
1
G1
40 °C
1000 m
LD F7RTC
9
15 Electro starter
16 Petrol Cock
17 Wheels
18 Carry handle
18a Carry handle mounting Set
19 Rubber feet
20 Battery
21 Transport handles
22 DC oulet adapter cable
23 Spark plug wrench set
24 Air filter set
25 Wheel assembling set
26 Spark plug
27 Selection switch 230 V~/400 V~
28 Muffler
6. Before putting the machine into operation
6.1 Wheel assembly (fig 3-4)
1. First place the axle on the frame and secure it with
fixing plates (item 25) through nuts and washers.
2. Then insert the washer,wheel and secure it with the
washer and nut .
3. Assemble the left side wheel with same procedure as
above.
Important:
The inner wheel should be inflated for it has been
shipped out with lower pressure (max. gauge pressure 3
bar/0.3 MPa).
6.2 Rubber feet assembly (fig. 5)
Hold the foot (item 19) against the frame as shown. First
place the bolt through the hole in the frame and the hole
in the foot and secure it with a nut. Then secure other
three bolts and nuts with same procedure.
6.3 Transport handle assembly (fig. 6-7)
Place the carry handle (item 18) on the frame and fix it
with the bolts and two washers as shown 6-2.
The user can adjust the position of carry handle for
G
B