Table of Contents
Advertisement
SKM_100_PRT.book Seite 18 Mittwoch, 4. Februar 2009 4:59 16
Adjusting settings via the operating menu
The extended menu
"Advanced
Setting transmission frequencies and the frequency bank "U" –
"Tune"
When you have selected one of the system banks and then select the
"Tune" menu, the radio microphone automatically switches to channel 1
of the frequency bank "U". In this case, "U.1" briefly appears on the display
panel. Upon delivery, the channels of the frequency bank "U" are not
assigned a transmission frequency.
When you are in the "Tune" menu item, the RF signal is deactivated.
Via the "Tune" menu item, you can set a transmission frequency to be
stored in the current channel
or
you can select a different channel and
assign it a transmission frequency. It is vital to observe the notes on
frequency selection on page 20.
Setting a transmission frequency for the current channel
Move the multi-function switch until the "Tune" menu item
appears.
Press the multi-function switch.
The frequency selection appears.
Advanced Menu
Tu n e
Tune
543
.200 MHz
B.Ch: 20.1
543.200 MHz
Call up
Select the MHz
"Tune"
value and confirm
"Stored"
Set the desired frequency.
Press the multi-function switch.
Your settings are stored.
You are back to the operating menu.
Selecting a channel and assigning this channel a frequency
Move the multi-function switch until the "Tune" menu item
appears.
Press the multi-function switch until the frequency bank
selection appears.
SET
Advanced Menu
Tu n e
Tune
B.Ch:
543.200 MHz
Call up "Tune"
Select the channel;
(special function)
store the setting
SET
"Stored"
Set the desired channel.
Press the multi-function switch.
The frequency selection appears.
Set the desired frequency.
18
Menu"
Tu n e
544.200
MHz
B.Ch: 20.1
Select the kHz
value; store the
setting
U.
1
Advertisement
Table of Contents
