Extrusion Instructions - 3devo Composer 35 User Manual

7.

EXTRUSION INSTRUCTIONS

Let it run for a couple minutes until it works
properly. The filament is ready to be wound
on the spool when the measured value of
the optical sensor is the same as the set
value.
Place the filament between the puller
wheels – when the filament is not too warm
any more. In case of being too warm; this
will warn off the puller wheels and will not
show a stable filament diameter thickness.
Let it run for a couple minutes until it works
properly. The filament is ready to be wound
on the spool when the measured value of
the optical sensor is the same as the set
value.
30