Table of Contents
Advertisement
4.14. SOFTWARE ERRORS
This section describes the most general errors, which could occur during the
extrusion process. If none of the steps below seems to concern your extruder's
situation. For additional questions, please contact us via support.3devo.com.
Error name
"The external supply voltage
is too low or absent."
"Reset signal received."
"Extruder motor too hot."
"Extruder motor current
limit reached."
"Positioner endstop hit
unexpectedly."
"Hopper is empty for too
long."
Information
This occurs when only the USB-cable is
connected or none at all. Please turn on the
mains electricity of the extruder with the 'On'
button on the back and check the power
cable.
This message is shown when the
USBconnection is opened on the PC. This
reset is necessary for us to upgrade the
firmware.
This occurs when the extruder motor has run
to hot due to too much friction generated by
the screw or extruding for a very long period
with high RPM settings.
This occurs due to too much friction
generated by the screw. The temperature
settings might not be correct.
End-stop hit by user or with the positioner.
This occurs when the hopper sensor detects a
low amount of granulate in the hopper.
27
Advertisement
Table of Contents
