3devo Composer 35 User Manual page 24

When the user acknowledges the warning,
a new prompt will ask the user to input the
timeout delay that will be used as safety
measure after the heater temperatures has
been reached. Rotate the navigation button
to select the timeout and edit the timeout
at will or continue by pressing 'Ok'.
After setting the timeout, the machine will
start as usual with the heating status. When
the heaters are on temperature, the status
will be set to 'Prepared'. During this period
the timeout is applied. The user will again
be asked to 'Start now' or 'Start later' in a
user prompt.
Extruding will be started directly when start
now is used. With the start later the user
will be returned to the status screen, while
showing a timeout countdown during this
period. See picture 'Waiting for start status
screen'. Within the set timeout period it is
possible to go to the main menu and press
the 'Start extrusion' to start extruding or
'Stop extrusion' to cancel the manual start
process and return to the Idle state.
When the extruder is not started within the
set timeout period, the extruder will be
stopped and set to its Idle state. The user
will receive a message prompt regarding
the timeout being reached as shown above.
20