Advertisement
Quick Links
ASSEMBLY AND INSTALLATION
T0389
WARNING:
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Warning:
LED electronics can be damaged by electro static discharge (ESD)shock. Before
installation, discharge yourself by touching a grounded bare metal surface to remove this
hazard. To avoid damage, do not touch the LED module.
Hardware Package (included):
Mounting Plate (A)
Mounting Screw (B)
Outlet Box
Wire Connector (E)
House Grounding Wire
Headless
Screw (H)
Fixture Grounding Wire
Mounting Plate
Green Grounding Screw (C)
Mounting Screw (B)
Lock Nut (D)
Installation Steps
Turn off the power at fuse or circuit box
1. Thread two headless screws (H) through the mounting plate (A),
then secure them with four lock nuts (D) ( two on each side
of the mounting plate (A) ). Adjust the length of the headless screws (H) if necessary ).
Note: Make sure that the headless screws (H) are lined up horizontally, to ensure that
the fixture will be level.
2. Attach the mounting plate (A) to the outlet box by using two mounting screws (B).
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Green Grounding
Screw (C)
(A)
Wire Connector (E)
Lock Nut (D)
Back Plate
Fixture Wire
Rubber Pad (G)
Ball Nut (F)
Ball Nut (F)
Rubber Pad (G)
Glass
Headless screw
Glass Holder
Ball Nut
180404
Headless
screw (H)
Advertisement
Related Manuals for Vaxcel T0389
Summary of Contents for Vaxcel T0389
- Page 1 ASSEMBLY AND INSTALLATION INSTRUCTIONS T0389 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
- Page 2 4. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections (E) using the wire connectors (E): ---Connect the black wire from the fixture to the black wire from the power source. ---Connect the white wire from the fixture to the white wire from the power source. ---Attach the fixture grounding wire to the cross bar with the green grounding screw (C).
- Page 3 CUSTOMIZATION OPTIONS: Shut-off Delay The Shut-off delay is the length of time the light will stay at high-level brightness after motion has ceased to be detected.This Shut-off delay can be set when operation is in 3, 6 or 0 Mode by using the “TIME” knob located on the left side of the panel at the back of the sensor lens (See Fig.2) .
- Page 4 ----In 3H or 6H Mode, the light turns off completely, instead of low level brightness, after 3 minutes: Make sure the low level is not at the 0% position. -- The light blinks: 1. Make sure the light is not mounted near a barbecue, air conditioner or other heat source. 2.