Vaxcel T0322 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0322
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read and save these instructions.
Important to Know
1. Read all instructions carefully before installation and
operation.
2. If you are not familiar with state and local electrical codes,
it is recommended that you consult with a qualified
electrician.
3. Before installation, shut off power at the main fuse or
circuit breaker box. Be aware that simply turning off the
wall switch is not sufficient to prevent an electrical shock.
4. This fixture requires a 120 VAC, 60 Hz power source.
5. Do not attempt to take the lantern apart; there are no
serviceable parts inside.
6. To avoid sensor damage by lightning or electrical surge,
make sure the grounding wire is securely connected.
7. For general safety and to avoid any possible damage to
the sensor, be sure the power is switched "off" before
replacing the bulb.
Maximum Wattage: 11W Dimmable LED
Work Temperature: - 4°F~104°F
Wire Nut (F)
Outlet Box
House Grounding Wire
Headless Screw (C)
Fixture Grounding Wire
Cross Bar (A)
Green Grounding Screw (E)
Mounting Screw (B)
Lock Nut (D)
INSTRUCTIONS
TOAVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Set Screw
Rubber Pad
Back Plate
Fixture Wire
Features
1. Energy saving fixture.
2. Use the dim-to-bright illumination option where
you want some minimum illumination through out
the night, such as at your front entrance or garage
door. Use the dark-to-bright illumination option
where you do not need minimum brightness, such
as the backyard or back porch.
3. When in manual override mode, use wall switch
to keep the light ON till dawn.
Hardware Package (included)：
Mounting Screw (B)
Cross Bar(A)
Green Grounding
Screw (E)
Rubber Pad (H)
Ball Nut (G)
Page 1/4
Headless Screw (C)
Rubber Pad (H)
Wire Nut (F) Ball Nut (G)
Curved Arm
Fixture
161028
Lock Nut (D)