ASSEMBLY AND INSTALLATION
T0362
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read and save these instructions.
Important to Know
1. Read all instructions carefully before installation and operation.
2. If you are not familiar with state and local electrical codes,
it is recommended that you consult with a qualified electrician.
3. Before installation, shut off power at the main fuse or circuit
breaker box. Be aware that simply turning off the wall switch is
not sufficient to prevent an electrical shock.
4. This fixture requires a 120V AC, 60 Hz power source.
5. Do not attempt to take the lantern apart; there are no
serviceable parts inside.
6. To avoid sensor damage by lightning or electrical surge, make
sure the grounding wire is securely connected.
7. For general safety and to avoid any possible damage to the
sensor, be sure the power is switched "off" before replacing the
bulb.
Maximum Wattage: 60W
Work Temperature: -4ºF ~ 104ºF
Hardware Package (included) :
Mounting Plate (A)
Wire Nut (E)
Front Glass panel (I) (X1)
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Incandescent Bulb
Mounting Screw (B)
Lock Nut (F)
Features
1. Energy saving fixture.
2. Use the dim-to-bright illumination option
3. When in manual override mode, use
Green Grounding
Screw (C)
Rubber Pad (G)
Page 1 / 4
where you want some minimum
illumination through out the night, such
as at your front entrance or garage door.
Use the dark-to-bright illumination option
where you do not need minimum
brightness, such as the backyard or
back porch.
wall switch to keep the light ON till dawn.
Side Glass Panel (J) (X3)
Ball Nut (H)
171022