Related Manuals for Anderson VFS82
Summary of Contents for Anderson VFS82
- Page 1 Anderson Thermal Solutions (Suzhou) Co., LTD VFS82 Burner Operation Manual No： ATS–Operation Manual–VFS82 VFS82 Burner Operation Manual Subject:： Version ： V1.0 Author ： Wilson Sun Review ： David...
-
Page 2: Table Of Contents
Liability And Warranty......................... 1 Safety Guide ..........................1 Fuel Information .......................... 2 VFS82 Series Burner Description ....................2 5.1 VFS82 Series Burner Advantages ..................3 5.2 VFS82 Series Burner Introduction ..................3 5.3 Ignition Burner ........................4 VFS82 Burner Operation Data ..................... 4 VFS82G Series Burner Installation .................... -
Page 3: Disclaimer Notice
Loss of or damage to the use of materials that sell, install, use, fail to use or repair or replace Anderson related products. -
Page 4: Fuel Information
1,013.25 mbar, 0°C 5. VFS82 Series Burner Description VFS82 series burners are the patented products of Anderson Thermal Solutions (Suzhou) Co., Ltd. Designed for high input capacity. It is widely used for industrial applications, including large dryers, ovens, calciners, kilns, thermal fluid heaters, thermal oxidizers, oil... -
Page 5: Vfs82 Series Burner Advantages
– suitable for different kinds of fuels such as natural gas, propane, light oil, or heavy oil. 5.2 VFS82 Series Burner Introduction VFS82 series burner includes burner body, gas or oil nozzle, ignition burner, spark rod and peep sight, vortex generator components, flame monitor device, etc. It is to be noted that flame monitoring must be provided by an ultraviolet scanner. -
Page 6: Ignition Burner
Anderson Thermal Solutions – VFS82 Burner Operation Manual 5.3 Ignition Burner VFS82 Series Burner has a separated ignition burner of maximum capacity 50kw. User need to supply fresh combustion air for ignition pilot, so, a small air blower or compressed air needs to be applied to the pilot burner. - Page 7 – Flame length and diameter measured here based on normal temperature combustion air and natural gas, and also the air gas ratio is 1:11 – Data above all based on natural gas, for other fuel, please contact Anderson Thermal Solutions (Suzhou) Co., Ltd.
- Page 8 Anderson Thermal Solutions – VFS82 Burner Operation Manual Burner operation curve shown as Fig. 3 and Fig. 4 below: Fig. 3 VFS82G Series Burner Operation Zone Fig. 4 VFS82G Series Burner NO Emission Zone VFS82G series burner gas pressure drop cross burner vs. input curve shown as Fig. 5...
- Page 9 Anderson Thermal Solutions – VFS82 Burner Operation Manual Fig. 5 VFS82G Series Burner Operation Gas Pressure Drop Curve VFS82G series burner air pressure drop cross burner vs. input curve shown as Fig. 6 Fig. 6 VFS82G Series Burner Operation Air Pressure Drop Curve Remark: Pressure drop refers pressure difference between burner and oven chamber.
-
Page 10: Vfs82G Series Burner Installation
VFS82 series of burner installation dimensions as Fig. 8. Fig. 8 VFS82G Serises Burener Installtion Diagram Different types of VFS82 burner dimensions shown as Table 2. Table 2 VFS82G Series Burner Installation Dimension VFS82G... -
Page 11: Burner Start, Commissioning And Stop
Anderson Thermal Solutions – VFS82 Burner Operation Manual 8. Burner Start, Commissioning and Stop For the first time burner startup, then you must follow these steps: 1. Reset the System: Close the automatic fuel shut-off valves and the fuel cocks. -
Page 12: Burner Maintenance
If necessary, the frequency of audit should be increased. Leak detection, control functions of the equipment must be included in the scope of audit. Only Anderson technicians or those who are been trained and qualified by Anderson, as well as other relevant professionals, can maintain the burners. -
Page 13: Troubleshooting Procedures
Anderson Thermal Solutions – VFS82 Burner Operation Manual 10. Troubleshooting Procedures Problem Possible Cause Solution Check air pressure switch adjustment. Cannot initiate a Air pressure switch has not made contact start sequence Check air filter. Check blower rotation. Check outlet pressure from blower. - Page 14 Anderson Thermal Solutions – VFS82 Burner Operation Manual Not enough gas: Start gas solenoid valve does Check solenoid valve coil for proper not open orientation. Replace if necessary Not enough gas: Gas valve not open, not Check wiring to the automatic gas shut-off enough gas.
-
Page 15: Appendix
Anderson Thermal Solutions – VFS82 Burner Operation Manual 11. Appendix 11.1 Training Record Each trained person must verify that he has read and understood the contents of the operating manual and know how to operate and maintain this series of burners correctly. -
Page 16: Annual Audit Record
Anderson Thermal Solutions – VFS82 Burner Operation Manual 11.3 Annual Audit Record Yearly audit list as follow but not only included Function Audit Date Inspector Problem description Next Audit Time Leak test Pressure switch test Cable and connectors Burner bodies and air wings Attention：...
Need help?
Do you have a question about the VFS82 and is the answer not in the manual?
Questions and answers