Sears 867.736349 Owner's Manual page 4

Optional Accessories
1. Tall Register Kit, Sears Stock No. 42-7312, For use
when replacing a "Dual Wail" furnace. Tall
register covers existing walt opening.
2. Shot;r Rear Wall Register Kit, Sears Stock No.
42-7313. For use when installing two-room
heating but not replacing "Dual Wall" furnace,
3. Vent Shield Kit, Sears Stock No. 42-7311. is
required when mounting the furnace on the sur-
face of the wall.
4. Horizontal Vent Kit, Sears stock No, 42-7369 is
required if furnace ;s to be vented horizontally
into on existing chimney.
I . I IIIIIIIIIII I II IIIIIIIIIIIIIJ I I I IIIIIIIIIIIII
IIIIIIIIIIIIIIIII II IIIII/11] IIIIIIIIII I IIIIIIIllll IIIIIIII
Furnace Data
MODEL
NUMBER
....867.736349
867.736389
INPUT**
TYPE RATING
GAS Btuh***
Nat. : 65,000
L,P.* 65,000
MAIN BURNER ORIFICE
2 REQUIRED
DRILL DEC.
...... 36 .1o65"
52 .0655"
PILOT ORIFICE
DECIMAL
.018"
.010"
*Liquefied Petroleum.
**For elevations above 2000 ft. reduce ratings 4% for each 1000 ft. above sea level.
***Btuh = British Thermal Units per hour.
BE SURE YOUR FURNACE IS EQUIPPED FOR THE TYPE OF GAS TO BE USED, EITHER NATU_,AL OR L.P. GA,5. THE
CONNECTIONS FROM THE L.P. BULK STOlYAGE TANK TO THE FURNACE CAN ONLY BE MADE BY A LICENSED
L.P. DEALER.
I ...................................................... __..I " L -
Unpack Your Furnace
The shipping carton contains the furnace and the
following items needed to install it.
1, Thermostat and wire -- packed inside lower
cabinet door (Fig. 1).
2. Top trim piece and small parts bag -- taped to
inside end of carton.
3. Vent support assembly -- in package taped to
end of furnace.
Store these items where they cannot be lost or
damaged.
Grasp each side of the cabinet door. Pull forward
and upward to remove (Fig. 1).
BE SURE YOUR FURNACE IS EQUIPPED FOR THE TYPE
OF GAS TO BE USED, EITHER NATURAL OR L.P.
CHECK THE RATING PLATE. IT IS ON THE PANEL JUST
ABOVE THE GAS VALVE.
Remove the cabinet door knob screw. Reinstall the
,knob on the outside.
Remove the two (2) screws holding the upper panel
(Fig. 1). Remove the panel for access to fan,
Remove the shipping bracket and tape from the fan
motor. Untape and remove the spacers between the
motor mount wires (Fig. 1).
t' [.</_L_-_ _ \ i !---=------': uPPeR
.- / / ! llUlli__ -_
' SHIPPING BRACKET _ r
SHIPPING RUNNER
CABINET - -
SHIPPING
RUNNER _---,._._.
CABINET DOOR "
SELECTOt_
SWITCH
KNOB
Reinstall the upper front panel, Stand the furnace
upright. Remove the runners (Fig. 1).
Place the selector switch knob (shipped in parts bag)
on the shaft sticking through the front panel (Fig. t).
4