Table of Contents
Advertisement
11. Using the screws SRW38, tighten the bracket M25 and the round terminal CN [an
earth wire used to connect the PDP module and the terminal panel VIDEO M59 (See
P.14)] together on the PDP module P01.
12. Set the clamper M04 in the bracket hole and insert the round terminal in the clamper.
13. Pass the AD cable CN-AD through the clamper and insert it in the connector D. Re-
move the screw E that has been attached to the PWB of the PDP module and fasten
the round terminal of the AD cable to the same place.
(Caution) Insert the side of the AD cable, where no "AD" label is present.
TOP
14. Insert the LD cable CN-LD in the LED PWB A11.
15. Using the one screw SRW02, mount the LED PWB on the
bracket M39.
16. Insert the SW cable CN-SW in the CTL PWB A09, and mount it
on the bracket by means of the two screws SRW02.
A
P01
B
E
SRW38
CN
A11
C
SRW02
A09
CN-SW
D
M25
M04
CN-AD
SRW02 x 2
P01
CN-LD
M39
3
Advertisement
Chapters
Table of Contents
