Integra PLA-50FP1 Manual page 117

6. Mount one each of the bracket filters M38 and M39 on the front
panel M01, using the five screws SRW01 for each.
Mount the two bracket filters M40 on the right and left of the front
panel, using the three screws SRW01 for each.
7. Stick the conductive cloth tapes M67-1 and M67-2 to cover the
junction parts of the copper foil tape sections of the bracket filter
and the filter M52.
(Caution) When using the conductive cloth tapes M67-1 and M67-
2, cut them to the lengths of 1130mm and 660mm, re-
spectively.
The conductive cloth tapes shall not be protruded from
the inner frame section of the filter.
8. Stick the cushion M49 to the top of each conductive cloth tape
M67-2 on the right and left.
9. Wipe off any contamination from the glass surface of the PDP
module P01, using ethyl alcohol.
10. Apply two mounting holes of the PDP module to the two position-
ing holes on the front panel, and mount the PDP module on the
front panel.
(Caution) Make sure not to hurt the front surface of the PDP mod-
ule.
SRW01 x 3 x 2
M67-2 x 2
M49 x 2
TOP
M40 x 2
M01
M38
M52
M67-1 x 2
M39
A
P01
SRW01 x 5 x 2
2