Page 1
SERVICE MANUAL BINKS MODEL 85-435 AIR PRESSURE REGULATOR Ind. Ind. Ref. Replacement Ref. Replacement Description Parts Description Parts Part No. Part No. Req'd. Req'd. 85-436 REGULATOR BODY O-RING (VALVE SEAT) 54-4945 PUSH-LOK FITTING VALVE SEAT TIA-4326 SAFETY VALVE RELIEVING DIAPHRAGM ...
Page 2
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PROVIDE THIS INFORMATION TO THE OPERATOR OF THE EQUIPMENT. FOR FURTHER SAFETY INFORMATION REGARDING THIS EQUIPMENT, SEE THE GENERAL EQUIPMENT SAFETY BOOKLET (77-5300). Binks reserves the right to modify equipment specification without prior notice. 2 / 4...
Page 3
REGULATOR DISASSEMBLY, CLEANING AND REASSEMBLY CLEANING WARNING 1. Clean parts using warm water and soap. 2. Inspect all parts. Risk of injury from pressurized components. Turn off inlet air pressure and bleed off remaining pressure 3. Replace damaged parts. before disassembly. REASSEMBLY DISASSEMBLY 1.
Page 4
WARRANTY POLICY Binks products are covered by Finishing Brands one year materials and workmanship limited warranty. The use of any parts or accessories, from a source other than Finishing Brands, will void all warranties. For specific warranty information please contact the closest Finishing Brands location listed below.