Sherwood NEWCASTLE R-945 Operating Instructions Manual page 6

_
Pre amplifier Plug this cord into a wall AC outlet
* When a separate pre amplifier is used for front channels,
connect these jacks to the pre amplifier and connect the front
speakers to this receiver.
r. @ PRE OUT connections
Front speakers
Power amplifier
Powered
Power amplifier Center speaker Subwoofer
Power amplifier
Rear speakers
¢ Use these jacks when adding additiona! amplifiers.
¢ Connect the PRE OUT jacks to the powered speakers or the power amplifiers
connected to speakers respectively.
¢ To emphasize the deep bass sounds, connect a powered subwoofer.
* When you do not use the front MAIN IN and PRE OUT jacks, always connect these
jacks with the supplied jumper plugs.
[
i
L
SWITCHED AC OUTLETS
These outlets are switched on and
off by the STANDBY button on the
front panel or the POWER button on
the remote control. (Maximum total
capacity is 100W)
Standby mode — switched AC outlet on
Power on mode — switched AC outlet on