Table of Contents
Advertisement
+ Speakers are not switched on.
¢ Press the SPEAKER ON/OFF switch to
ON.
* Incorrect connections between the
* Make connections correctly.
components.
¢ Select a surround mode.
¢ Adjust master volume and rear level.
No sound from the rear
speakers
* Surround mode is switched off.
¢ Master volume and rear level are too
low.
* Monaural source is used.
* Dolby 3 Stereo mode is selected.
¢ Select a stereo or surround source.
« Select the desired surround mode,
speaker
« DTS,Dolby Digital(AC-3), Dolby Pro
Logic or Dolby 3 Stereo mode is not
selected.
¢ Master volume and center level are too low.
¢ Adjust.master volume and rear level.
¢ Connect an antenna.
¢ Tune in the desired station frequncy.
¢ No antenna is connected.
« The desired station frequency is not
tuned in.
¢ Antenna is in wrong position.
Stations cannot be received
¢ Move antenna and retry tuning.
Preset stations cannot be
received
¢ The memorized stations are cleared.
¢ Memorize the stations again.
¢ Connect an antenna.
« Change the position of the antena.
¢ No antenna is connected.
¢ The antenna is not positioned for the
best reception.
Poor FM reception
Continuous hissing noise
during FM reception,
especially when a stereo
broadcast is received.
Cnotinuous or intermittent
hissing noise during AM
reception, especially at night.
* Change the position of the antenia.
¢ Weak signals.
¢ Install an otudoor antenna.
» Keep the receiver away from noisesources,
¢ Install an outdoor AM antenna.
¢ Noise is caused by motors, fluorescent
lamps or lightning, etc.
¢ DIGI LINK connections are not made
properly.
A video label cannot be
displayed.
* Clear it using " To clear a video IbeL"
(Refer to "Rectifying or clearing: video
label" on page 27)
« Mulfunction due to external influences
such as static electricity, etc.
31
x
®
=
Oo
z
ii
Advertisement
Table of Contents
